EMS COBALT C0405 Series Operator's Manual page 34

C H A P T E R 3 : P O W E R & C O M M U N I C A T I O N
This procedure can be used to cycle through all 16 possible Subnet Nodes. Note that
after reaching Subnet Node 16, incrementing the Node ID value once more returns
the controller to Node ID 0.
After selecting the desired Node ID value, reset the C0405 with the Configuration Tag
out of RF range to allow the unit to reset completely and resume operation under its
new Node ID.
S et ti ng N od e ID Aut om at i ca l l y ( C0 405 -48 5 o n l y)
To allow a Subnet16 Gateway or Hub to assign the Subnet Node ID to a C0405-485
automatically, reset the controller to Node ID 00, connect the controller to the network,
and apply power to the Subnet16 bus. When the Gateway or Hub comes on line,
hold the Configuration Tag in the RF field of the controller for several seconds to
allow the Gateway or Hub to assign the next available Node ID value. For more
information on using a Subnet16 Gateway and Hub product to auto-assign Subnet
Node ID values, please refer to the Operator's Manuals for theSubnet16 Gateway
and/or subnet16 Hub.
C 0 4 0 5 - X X X - 0 1 O P E R A T O R ' S M A N U A L – R E V . 0 3 P A G E 3 4 O F 7 5