Mounting The Controller; Figure 2-2: C0405 Controller Attached To Bracket With Cable Connected - EMS COBALT C0405 Series Operator's Manual

2 . 1 . 3
M o u n t i n g t h e C o n t r o l l e r
C0405-Series RFID Controllers can be mounted to wood or plastic fixtures. The units'
ship with an L-shaped, polycarbonate, mounting bracket and the necessary hardware
required to fasten the controller to the bracket. The bracket is designed to help isolate
the RFID controller from metal surfaces and the affect of spurious noise electronically
conducted through metal.
NOTE: The controller may be mounted horizontally or vertically, but should be aligned
in such a manner that the LED indicators can be seen during operation.
1. Select a suitable location to mount
the C0405 Controller.
2. Attach the C0405 Controller to the
mounting bracket using the two sets
of M4 screws, washers and nuts
provided. Place the nuts in each of
the two hex-shaped recessed
cavities at the rear of the C0405.
3. After aligning the mounting bracket
with the two mounting holes on the
controller, insert both M4 screws
(with washers) into the controller
from the underside and tighten
completely using a standard Phillips
#2 head screwdriver.
4. Fasten the other end of the mounting
bracket to your work area.
T or qu e Spe c if ic at io n
Tighten the two M4 screws used to fasten the controller to the bracket (and any user
provided screws used to mount the bracket to the work area) to the following torque
setting: 0.7 Nm or equivalent to 6 lbs / inch
C 0 4 0 5 - X X X - 0 1 O P E R A T O R ' S M A N U A L – R E V . 0 3

Figure 2-2: C0405 Controller Attached to Bracket with Cable Connected

C H A P T E R 2 : I N S T A L L I N G T H E C 0 4 0 5
P A G E 1 7 O F 7 5