Mocka Aspen Classic Cot Assembly Instructions

Aspen Classic Cot
Assembly Instructions
Thank you for your purchase.
Please follow the manufacturers assembly instructions in detail
to ensure the safety features of the cot are not compromised.
A B C
8x 16x 8x
bolt bolt bolt

Hardware Supplied

Ensure the cot is placed at a reasonable distance from curtains, blinds, heaters and power points.
Keep all medications, string, elastic, small toys or small items, such as money, out of reach from
any position in the cot.

Assembly

Care must be taken when attaching sides. Do not over-tighten screws as this can cause damage
to the cot.

Care and Maintenance

Regularly check all screws for tightness or damage that could render the cot unsafe.
To clean - use a damp cloth, avoiding the use of detergents or abrasives.

Recommended mattress size

This cot has been manufactured for use with a mattress which measures 1300mm long x 690mm
wide x 100mm in thickness. The width and length are specified because it is important that gaps
between the mattress and the sides and ends of the cot will not exceed 40mm when the mattress
is pushed to one side or end, and 20mm when the mattress is centred in the cot. This is to
minimize the risk of a child's limb becoming caught in the gap. The thickness of the mattress has
been specified to ensure that the depth of the cot is greater than 500mm with the mattress base in
the lower position to minimize the risk of a child climbing or falling out of the cot.

Flathead screwdriver required

mocka.co.nz | mocka.com.au | PO BOX 18, Pinkenba QLD 4008
D E F
8x 8x 2x
nut dowel allen key
WARNING: TO PREVENT FALLS, THE MATTRESS BASE OF THIS COT SHOULD
G
BE ADJUSTED TO THE LOWEST POSITION BEFORE THE CHILD CAN SIT UP.
4x
screw
nut
1