Active Data Connections - Nokia 5800 XpressMusic User Manual

WLAN security mode
●
WEP, 802.1x (not for ad hoc networks), or WPA/WPA2. If
you select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
Homepage — Enter the web address of the starting page.
●
Use access point — Select
●
want the device to ask for confirmation before the
connection using this access point is created or
Automatically if you want the device to connect to the
destination using this access point automatically.
To enter the settings for the selected security mode, select
WLAN security settings.
Security settings for WEP
WEP key in use — Select the wired equivalent privacy
●
(WEP) key number. You can create up to four WEP keys. The
same settings must be entered on the WLAN access point
device.
Authentication type
●
authentication type between your device and the WLAN
access point device.
WEP key settings — Enter
●
the key), WEP key format (ASCII
WEP key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2
WPA/WPA2 — Select the means of authentication:
●
to use an extensible authentication protocol (EAP) plug-in,
or Pre-shared key to use a password.
Complete the appropriate settings:
74
— Select the encryption used:
After confirmation
— Select Open or Shared
WEP encryption (length of
or Hexadecimal), and
EAP plug-in settings
●
to the instructions from your service provider.
Pre-shared key
●
password must be entered on the WLAN access point
device.
WPA2 only mode
●
if you allowed to establish a connection in this mode.
Advanced WLAN settings
Select Options
following:
IPv4 settings
●
subnet IP address, the default gateway, and the IP
addresses of the primary and secondary DNS servers.
Contact your internet service provider for these addresses.
IPv6 settings
●
Ad-hoc channel
●
number (1-11) manually, select
Proxy server address
●
server.
for the
Proxy port number
●

Active data connections

Select Menu
mgr..
In the active data connections view, you can see the open
EAP
data connections:
data calls
packet data connections
wireless LAN (WLAN) connections
— Enter the settings according
— Enter a password. The same
— Only WPA2 enabled devices are
Advanced settings
>
— Enter the IP address of your device, the
— Define the type of DNS address.
(only for Ad-hoc) — To enter a channel
User
— Enter the address for the proxy
— Enter the proxy port number.
Settings and Connectivity
>
© 2009 Nokia. All rights reserved.
and from the
defined.
Connection
>