Table of Contents
Advertisement
WLAN internet access points
Select
Menu
Ctrl. panel
>
Connection
Destinations
>
follow the instructions on the display. Or, open one of
the access point groups, select an access point marked
with
, and select Edit.
Use the instructions provided by your service provider
to edit the following:
Connection name
•
connection.
Data bearer
— You might not be able to edit the
•
data bearer once defined. Define a new access point
if needed.
WLAN network name
•
Search for
networks. If you select an existing
network,
WLAN network mode
security mode
access point device.
Network status
•
name is displayed.
WLAN network mode
•
an ad hoc network, and to allow devices to send and
receive data directly; a WLAN access point device is
not needed. In an ad hoc network, all devices must
use the same WLAN network name.
WLAN security mode
•
used: WEP, 802.1x, or WPA/WPA2. (802.1x and
WPA/WPA2 are not available for ad hoc networks.)
If you select
Open
The WEP, 802.1x, and WPA functions can be used
only if the network supports them.
62
Use access point
•
set the device to ask for confirmation before the
Settings
and
>
Access
point, and
>
— Define a name for the
— Select
Enter manually
and
WLAN
are determined by the settings of its
— Define whether the network
— Select
Ad-hoc
— Select the encryption
network, no encryption is used.
— Select
After confirmation
connection using this access point is created or
Automatically
destination using this access point automatically.
To enter the settings for the selected security mode,
select
WLAN security
Advanced WLAN settings
Select
Options
following:
IPv4 settings
•
the subnet IP address, the default gateway, and the
IP addresses of the primary and secondary DNS
servers. Contact your internet service provider for
these addresses.
IPv6 settings
•
or
Ad-hoc channel
•
enter a channel number (1-11) manually, select
defined.
Proxy server address
•
proxy server.
Proxy port number
•
number.
to create
Active data
connections
Select
Menu
mgr..
Select
Active data
In the active data connections view, you can see the
to
open data connections:
to set the device to connect to the
settings.
Advanced settings
>
— Enter the IP address of your device,
— Define the type of DNS address.
(only for ad hoc networks) — To
— Enter the address for the
— Enter the proxy port
Ctrl. panel
Connectivity
>
>
connections.
and from the
User
Conn.
>
Advertisement
Table of Contents
