Kessler AT-AUTO Operating Manual page 49

41
Operation with Multiple Rigs
With the added features included in AT-AUTO firmware since version 2.14, the user
(tm)
may also use a CX-AUTO coaxial antenna switch to switch between multiple radios
(tm)
via the AT-AUTO front panel controls. The radios used may consist of any transceiver
(tm)
make/model including icom CI-V equipped transceivers. The radios used need not be CI-V
equipped.
Figure 4.11 shows the AT-AUTO connected to two CX-AUTO coaxial antenna
(tm) (tm)
switches, one for input rig selection and one for automatic antenna selection. Make the
electrical connections as shown in 4.11 and configure the AT-AUTO per the instructions
(tm)
found in the Setup Multi-Rig section on page 70. When using the multi-rig setup, the
AT-AUTO will utilize CI-V frequency information whenever an Icom CI-V equipped radio
is selected, and when a non CI-V equipped radio is selected, will automatically revert to
counting the RF frequency to determine band and frequency.
www.KesslerEngineeringLLC.com