Kessler AT-AUTO Operating Manual page 111

the type of information contained in the serial data string. The Yaesu FT-1000, for
example, does not provide this information and thus "Y" cable operation with the
FT-1000 is still problematic.
Version 2.04
AT-AUTO firmware version 2.04 includes the following new features:
(tm)
1. Continuous display of the selected RF output (balanced/coax) while in Automatic
mode.
2. Elimination of the ability of the user to rotate the roller inductor past the '000' position,
thereby removing the likelihood that the roller inductor will be driven past the '000'
position and strike the physical stop.
Version 2.01
AT-AUTO firmware version 2.01 includes the following new features:
(tm)
1. Automatic L and C homing - During installation of firmware version 2.01 (and newer),
the AT-AUTO
2. L and C synchronization tracking - If the user switched the AT-AUTO
L or C position information was successfully written to non-volatile memory, then the
AT-AUTO
(tm)
On. After completion of the homing operation, C will automatically be repositioned
to 250.
Version 2.00
AT-AUTO firmware version 2.00 includes the following new features:
(tm)
1. Kenwood CAT support - Provides QSY-following of Kenwood CAT-enabled radios by
polling frequency information via the Kenwood CAT (serial data) port (Tested with
TS-570D).
2. Yaesu CAT support - Provides QSY-following of the FT-2000 as described above for
Kenwood. (Tested with FT-990, and FT-2000).
will home L and C, and then preset C to 250.
(tm)
will automatically home L and C when the AT-AUTO
www.KesslerEngineeringLLC.com
103
Off before
(tm)
is next turned
(tm)