Kessler AT-AUTO Operating Manual page 114

whenever high SWR was encountered. This problem is now fixed
3. When remotely controlling the AT-AUTO
information. The LCD operation during remote control operation has been corrected.
Version 2.09
AT-AUTO firmware version 2.09 includes these changes/corrections:
(tm)
1. QRO keyline was sometimes unpredictable when in automatic mode, if the firmware
was configured with QRO Enable == Yes, and QRO While Tuning == No. Version
2.09 corrected this.
2. .When configured to automatically bypass a specific band, if several band changes
were made in rapid succession, automatic band bypassing was sometimes erratic and
unpredictable. This problem has been corrected in version 2.09.
Version 2.07
AT-AUTO firmware version 2.07 includes this change/correction:
(tm)
1. A bug was found that affected the initial recall of match settings when switching
the RF outputs. This problem only manifested when the AT-AUTO
frequency information via the CAT/CI-V interface and had subsequently recalled and
set the L and C to the appropriate match settings for the selected output (the coax
output for example). If the user then switched the AT-AUTO
for example, the AT-AUTO
output unless either the frequency was subsequently changed or unless an RF carrier
was produced and the AT-AUTO
has been corrected. Now whenever the RF output is changed, the AT-AUTO
immediately reposition L and C for the active RF output.
Version 2.06
AT-AUTO firmware version 2.06 includes this change/correction:
(tm)
1. A bug was found that occasionally affected storage of match settings after "fine tune"
had been commanded. Under some very specific circumstances the revised match
setting was either not updated in memory, or else an incorrect setting was occasionally
stored. The "fine tune" bug affected all previous firmware versions. Version 2.05
contains this bug fix but no other changes.
would not recall and reposition L or C for the balanced
(tm)
(tm)
www.KesslerEngineeringLLC.com
, the LCD did not always display correct
(tm)
subsequently detected a mismatch. This bug
106
had received
(tm)
to balanced output
(tm)
will
(tm)