Kessler AT-AUTO Operating Manual page 37

Icom Rig & Tokyo Hy-Power HL-1.5KFX with AT-AUTO
Connections for using an Icom radio with a Tokyo Hy-Power HL-1.5KFX and an AT-
AUTO are shown in Figure 4.5. The HL-1.5KFX and the AT-AUTO
(tm)
frequency information via the CI-V bus whenever the radio's frequency changes. The radio
should be set to CI-V Transceive mode (see your owner's manual).
Thoroughly read through the Tokyo Hy-Power HL-1.5KFX manual as well as the Icom
radio manual, particularly the sections regarding CI-V (sometimes referred to as Remote)
operation. Then read through the AT-AUTO
to setup the AT-AUTO
1. Insert the Amphenol plug into the TRANSCEIVER DATA INPUT socket on the
rear of the AT-AUTO
2. Insert the male 3.5 mm plug into the Remote jack on the back of the Icom radio
3. Insert the 4-pin white Molex plug into the corresponding receptacle located on the
back of the Icom radio. Some radios may not include the 4-pin receptacle (IC-7800 for
example)
4. If using the optional QRO Keyline, the transmit control line must be routed through
the QRO Keyline connectors on the back of the AT-AUTO
QRO Keyline section on page 43 to configure the QRO Keyline.
5. Set the radio type to either "Icom Normal CI-V & Ext Tuner I/O" or set to "Icom CIV
Only No Ext Tuner I/O" as described in the Configure Radio section on page 52.
6. Setup the AT-AUTO
CI-V address to 0x5C as described in the Setup Icom CI-V section on page 59. The
default AT-AUTO
7. Configure the AT-AUTO
AT-AUTO
(tm)
of 9600 baud and the AT-AUTO
8. Set the Icom radio to 9600 baud
9. Consult the radio user's manual and set the Icom radio CI-V address to 0x5C and
"CI-V Transceive" to On and "CI-V with IC-731" to Off
10. Confirm that the AT-AUTO
on the Icom transceiver.
, HL-1.5KFX, and Icom transceiver.
(tm)
and twist the attachment ring until finger tight
(tm)
to "CIV Transceive From Select Icom" and also set the radio's
(tm)
CI-V address is 0xE0, which should require changing.
(tm)
serial I/O to 9600 baud as described in the Configure
(tm)
Serial Interface section on page 50. Most Icom radios use a default
is also set to 9600 baud by default from the factory
(tm)
and HL-1.5KFX are able to follow frequency changes
(tm)
www.KesslerEngineeringLLC.com
manual. The following are suggested steps
(tm)
(tm)
will receive
(tm)
. See AT-AUTO
(tm)
29
(tm)