Bosch DIVAR IP all-in-one 6000 User Manual page 10

10 en | System setup
4.
5.
6.
7.
8.
9.
10. After the installation is complete, the system restarts and you are directed to the
11. The Microsoft Edge browser opens and the DIVAR IP - System setup page is displayed.
2022-10 | V01 | F.01U.408.604
Click Accept to accept the license terms and wait until Windows restarts. This can take
several minutes. Do not turn off the system.
After restart, the Windows sign-in page is displayed.
Set a new password for the administrator account BVRAdmin and confirm it.
Password requirements:
– Minimum 14 characters.
– At least one upper case letter.
– At least one lower case letter.
– At least one digit.
Then press Enter.
The Software Selection page is displayed.
The system automatically scans the local drive and any connected external storage media
for the DIVAR IP System Manager installation file SystemManager_x64_[software
version].exe, which is located in a folder with the following structure: Drive
root\BoschAppliance\.
The scan might take some time. Wait for it to complete.
Once the system has detected the installation file, it is displayed on the Software
Selection page. Click the bar that displays the installation file to start the installation.
If the installation file is not found during the scan process, proceed as follows:
– Go to https://downloadstore.boschsecurity.com/.
– Under the Software tab, select BVMS Appliances from the list, then click Select.
A list of all available software packages is displayed.
– Locate the ZIP file SystemManager_[software version].zip and save it to a storage
medium such as a USB stick.
– Unzip the file on the storage medium by making sure that the folder BoschAppliance
is placed in the root of the storage medium.
– Connect the storage medium to your DIVAR IP all-in-one system.
The system will automatically scan the storage medium for the installation file.
The scan might take some time. Wait for it to complete.
– Once the installation file is detected, it will be displayed on the Software Selection
page. Click the bar that displays the installation file to start the installation.
Note: To be automatically detected, the installation file must be located in a folder
with the following structure: Drive root\BoschAppliance\ (for example F:
\BoschAppliance\).
If the installation file is located at another location that does not match the pre-
defined folder structure, click
click the installation file to start the installation.
Before the installation starts, the End User License Agreement (EULA) dialog box is
displayed. Read the license terms, then click Accept to continue. The installation starts.
Windows sign-in page. Sign in to the administrator account.
The page shows the device type and the device serial number, as well as the three
operation modes and the available software versions for each operation mode.
You must choose the desired operation mode and the desired software version to
configure your DIVAR IP all-in-one system.
Note: If the desired software version for the respective operation mode is not available
on a local drive, proceed as follows:
to navigate to the respective location. Then
User manual
DIVAR IP all-in-one 6000
Bosch Security Systems B.V.