Replacing The Fuse - Silvercrest SILH 4 A1 Operating Instructions Manual

Replacing the fuse

There is a fuse in the car/USB adapter
vehicle's on-board power supply . If the car/USB adapter
stops working, check the fuse and replace it if necessary .
DANGER
► Always use the same type of fuse! Otherwise there is a
risk of fire .
♦ Open the car/USB adapter
and removing the screw insert (C) anticlockwise .
♦ Remove the plug tip (B) from the fuse (A) and pull out the
fuse (A) .
♦ Now insert a new fuse (A) of the type F4AL250V into the
car/USB adapter
protruding end of the fuse (A) and screw the previously
removed screw insert (C) back in .
NOTE
► If the car/USB adapter
new fuse burns out immediately, the device is defective .
Please contact the Service Hotline (see section Service) .
SILH 4 A1
by carefully unscrewing
. Place the plug tip (B) onto the slightly
still does not work or if the
for protecting the
GB │ IE │ NI │
13 ■