Silvercrest SILH 4 A1 Operating Instructions Manual page 14

♦ Connect the micro-USB plug of the connection cable
to the connection socket (micro-USB)
The operating LED lighting
that the car cradle is ready for operation .
♦ Place your mobile phone on the supports
cradle . The holding clamps
cally move inwards .
NOTE
► Some mobile phones need to be taken out of their case
for charging .
♦ Charging starts immediately and is indicated on the dis-
play of the mobile phone . The pulsating operating LED
lighting
charged . When the mobile phone is fully charged, the
operating LED lighting
♦ Lift the mobile phone to remove it from the car cradle .
The holding clamps
move outwards .
♦ When charging is complete, disconnect the car/USB
adapter
on-board socket .
CAUTION
► In vehicles in which the 12/24 V on-board socket also
works with the ignition switched off, the mobile phone
must be disconnected after the 12/24 V on-board
socket after use . Otherwise, the vehicle battery can
be depleted over an extended period of time, as the
mobile phone and the car/USB adapter
draw power even when it is idle .
SILH 4 A1
also signals that the mobile phone is being
of the car cradle automatically
on the grip bracket
lights up blue and signals
of the car cradle automati-
goes out .
from the 12/24 V
GB │ IE │ NI
of the car cradle .
of the car
may still
│
11 ■