Table of Contents
Advertisement
COMISSIONING & PROGRAMMING
Clicking the green button with the arrow on it on the right
side of the Ubiquity Cloud Connection Status title bar will
refresh the connection status .
CONTROLLER VIEW
This section allows you to see what controllers have been
found by the QWL Panel and view each controller's address,
model, and communication status. The state field will show
AUTO-DETECTED initially when found by the unit and CON-
FIRMED once the controller has been recognized by the
Ubiquity Cloud central server. This information allows the
installer to verify that each controller has been found by the
QWL Panel and is communicating with the local network .
Clicking the green button with the arrow on it on the right
side of the Controller View title bar will refresh each con-
troller's status.
SYSTEM COMMANDS
In this section you are able to set a couple of system flags
for the QWL 3 .1 Rev 3 Series Panel itself. "Reboot Unit"
sets a flag which will shut off and restart the QWL 3 .1 Rev
3 Series Panel within a 5 minute Cycle. "Check for Update"
contacts the Ubiquity Cloud central server for any updates
relevant to its particular model number and software ver-
sion. Once the update has been downloaded, it is automati-
cally applied, and the unit may reboot.
NOTE: The "Check for Update" command requires that the
QWL 3 .1 Rev 3 Series Panel has Internet access to retrieve
the update patch .
7
2800 Laura Lane • Madison, WI 53562 | 800.288.9383 • fax: 608.836.9044 | www.tcsbasys.com
Programming - Lighting Module
The lighting module portion of this panel is an SLQ218. It
must be programed using TCS Insight or Ubiquity Cloud.
CHANNEL EVENT SCHEDULING
There are eight independent channels each with its own
schedule. If the occupied or "ON" time for a particular day
is from 8:00AM to 5:00PM. In the schedule enter 8:00 to
17:00. Within the Ubiquity Cloud programming page, the
desired schedule is simply selected from the drop-down
menu for each channel. If the desired schedule is not
shown in the drop-down, new schedules can be created or
existing schedules can be edited on the Scheduling page.
CHANNEL HOLIDAY SETUP
Holidays are created as part of the Scheduling page and
will appear as part of the selected schedule. You can cre-
ate date specific holidays, roaming holidays, or select from
a list of standard bank holidays. If the selected schedule
does not include the desired holiday(s), the schedule can
be edited on the Scheduling page.
ENABLE BLINK OUTPUT
The Blink Output option forces the respective lighting out-
put turn off four times, five minutes prior to an unoccupied
or off period. This will give an indication that a scheduled
on time is about to end. Click the checkbox to enable this
function for each channel.
ENABLE ASTRONOMICAL TIME
The Astronomical Time option allows the controller to turn
a channel off based on the locations sunrise and sunset
times. See the Astronomical Time section later in the man-
ual for more details and additional configuration options.
Click the checkbox to enable this function for each chan-
nel.
WHEN CHANNEL IS "ON"
You can select how you want the time clock output (Digital
Output Mode) to behave when the channel is occupied or
"ON". You can choose for the Relay to be Normally Open
or Normally Closed during on periods. Simply select the
desired behavior form the drop-down menu.
Advertisement
Table of Contents
