Foster Multideck FMPRO900NG Service Manual page 8

Service Level Parameters
Description:
SCL
2 Readout scale.
SPL -1 Minimum limit for Temperature Set Point (SP)
SPH 5 Maximum limit for Temperature Set Point (SP)
SP 0 Temperature setpoint to be achieved.
C-H REF Temperature control mode.
HYS 3 Off / On thermostat differential.
CRT 2 Compressor rest time.
CT1
6 Compressor run time with faulty T1 probe.
CT2 2 Compressor off time with faulty T1 probe.
CSD 1 Compressor stop delay after door has been opened. (Only if DS = YES).
DFM TIM Defrost start mode.
DFT
4 Time interval between defrosts in hours
DFB YES Defrost timer clock.
DLI 10 Defrost end temperature (Only if T2 = YES).
DTO
15 Maximum defrost duration.
DTY OFF Defrost type.
DPD 0 Evaporator pump down. Timed pause at start of defrost.
DRN 1 Drain down period.
DDM
SP Defrost display mode.
DDY 10 Defrost display delay period.
FID YES Evaporators Fans operate in defrost.
FDD 5 Evaporator fan restart temperature following defrost. (Only if T2 = YES).
FTO
2 Maximum evaporator fan stop period following defrost.
FCM NON Evaporator fan mode during thermostatic control.
FDT -1 Te-Ta difference for fans to turn off after compressor stopped. (Only if T2 = YES and FCM = TMP).
FDH
3 Temperature differential for evaporator fan restart. (Only if T2 = YES and FCM = TMP).
FT1 15 Fan stop delay after compressor stop.
FT2 3 Timed fan stop following FT1. (With FT2 = 0 the fans remain on all the time).
FT3 2 Timed fan run following FT2. (With FT3 = 0 & FT2 > 0 the fans remain off all the time).
ATM
REL Alarm threshold configuration.
ALA -2 Low temperature alarm threshold.
AHA 8 High temperature alarm threshold.
ALR -5 Low temperature alarm differential. (With ALR = 0 the low temperature alarm is excluded).
AHR
8 High temperature alarm differential. (With AHR = 0 the low temperature alarm is excluded).
ATI T3 Alarm probe.
ATD 90 Delay before alarm temperature warning.
ADO
8 Delay before door open alarm warning.
AHM ALR Operation in case of high condenser alarm.
AHT 65 Condenser alarm temperature (T3 = CND).
ACC 0 Condenser cleaning period. (With ACC = 0 condenser cleaning is disabled).
IISM
NON Switchover method to 'Mode 2'
IISL 1 Minimum limit for Mode 2 Temperature Set Point
IISH 1 Maximum limit for Mode 2 Temperature Set Point
IISP 1 Temperature setpoint to be achieved in 'Mode 2' .
IIHY
4 Off / On thermostat differential in 'Mode 2' .
IIFC NON Evaporator fan mode during 'Mode 2' thermostatic control.
HDS 3 Controller sensitivity for switch over between 'Modes' 1 and 2. (1 = minimum, 5 = maximum).
IIDF
6 Time interval between defrosts in 'Mode 2' .
8 www.fosterrefrigerator.com