Vantrue Element 3 User Manual page 23

-Loop Recording: Default setting is 3 min. You can choose the options
among 1/3/5 min and OFF.
-IR LEDs: Default setting is Auto. You can select auto, on, or off.
-G-Sensor: Select the level of G-sensor you need, then you can set 3
directions (Front + Rear/Left + Right/Up + Down). The G-sensor value in
each direction can be selected as 1/2/3/4/5/Off. The higher the
sensitivity level, the easier it is to trigger event recording. G-sensor is most
sensitive when set to 5.
-Audio Recording: The default is ON. Set recording to on or off.
-Exposure: The default value is +0.0. Adjust the exposure of the lens.
-REC Status Light: Default setting is ON. You can choose to turn on/off the
recording status light.
-WDR: Default is ON. For a better-balanced video effect, you can
choose to turn it off. This function is only for front and interior lenses.
-Rear HDR: The default is ON. Set recording to on or off.
-Rotate Display: Default is off. You can choose to flip the video screen up
and down(180 degrees).
-Cabin Mirror: The default is ON. If you turn it on, the internal recording
screen is displayed in mirror mode.
-Rear Mirror: The default is ON. If you turn it on, the rear recording screen
is displayed in mirror mode
-Number Plate: Select the number or letter to be set. After setting, your
license plate number can be displayed in the recorded video.
-Stamp: Enable or disable the watermark stamp on video and photos.
The watermark stamp includes time and date label, VANTRUE label,
license plate number, GPS location information, and speed label. All
enabled by default.
-Time Lapse: The default value is disabled. You can choose to enable
1FPS/5FPS/10FPS/15FPS.
-Parking Mode: You can choose the parking mode you need, including
Collision Detection/Motion Detection/Low Bitrate Recording/Low
- 19 -
N E N N E N N E N E N E N E E E