Advertisement
Mounting set
INFM7 Infinity Mounting set Universal
__________________________________________________________________________________
WARNING!
One clamp (G) is to be mounted on each
side of the holder (D) to avoid that the bar
breaks due to fatigue stress.
Now mount the complete adapter bar that
consists of center pipe (A), outer pipe (B)
and clamp (C). The complete adapter bar is
mounted into the holders (D) by using the
QR-pins (E).
Make sure the ends of the outer pipe (B)
are parallell otherwise it can be hard to
assemble it into the holders (D). It shall be
possible to move the center pipe sideways
and also rotate it if correctly assembled.
Now tighten the screws in all of the clamps (G).
INFO
Check that the arrow on the labeling mounted on the center pipe (A) is pointing towards the
front of the wheelchair. If the center pipe (A) is mounted the wrong way around it will not be
possible to attach Liberty to the bar.
7-9Nm of torque (M6)
10-15Nm of torque (M8)
__________________________________________________________________________________
Sida 5/8
Advertisement
