Axminster PROFESSIONAL AP2920B Original Instructions Manual page 22

BLADE CHANGE
Fig 81-82
• Clean crud from the tyres and remove any small
off cuts that may be around the bottom blade guide
set, (fig 83-84).
• Use the blade selection guide on pages 17-18 to
ensure that you have the right blade for the job!
Fig 83-84
Fitting the new Blade
• Slide the new blade through the table slot taking
care not to twist or distort the blade, then guide
the left hand side of the blade around toward the
machine and through the slot at the spine of the
machine, (fig 85-86-87).
Fig 85
Fig 86
Fig 87
• Guide the blade through the upper blade guard
and both the top and bottom blade guides
positioning the blade approximately in the middle
of firstly the top and then the bottom of the wheel,
(fig 88).
Fig 88
• Apply blade tension using the tension lever then
fine tune using the tension / tracking guide on
pages 08-09-10.
• Reattached the table insert, the table alignment
pin and wooden plate then close the doors.
22