Zoetis AlphaTrack3 User Manual page 18

Specifications (continued)
Meter (continued)
Safety EN 61010-1:2010; IEC 61010-1:2010/AMD1:2016 COR1:2019; IEC 61010-2-101:2018, EN 61010-
2-101:2017; EN ISO 15197:2015 (Clause 5.9 & 5.10) EMC/RF: EN 61326-1:2013; IEC 61326-
1:2020; EN 61326-1:2021; EN 61326-2-6:2013; IEC 61326-2-6:2020; EN 61326-2-6:2021; EN
60601-1-2:2015; FCC Part 15 B (Class B ANSI C63.4-2014); J55011 (H27):2015 EN 301 489-1
V2.2.3:2019-11; EN 301 489-17 V3.2.4:2020-09; EN 300 328 V2.2.2:2019-07; EN 62479:2010
EMC FCC Part 15 B, IEC 60601-1-2:2014, IEC 61326-1:2012,
IEC 61326-2:2012, J55011 (H27):2015
Pollution
Degree 2
Communication method Bluetooth
Operating Frequency Range 2402.0 - 2480.0 MHz
Operating Output 0.000234 W
Test strips
Storage temperature 36 to 90 °F (2 to 32 °C)
Storage relative humidity 0% to 90% (non-condensing)
Altitude
Storage: 54 kPA (5000 m)
Strip Open vial 12 months
Control solution
Storage temperature
39 to 86 °F (4 to 30 °C)
Storage relative humidity 0% to 90% (non-condensing)
Altitude Storage: 54 kPA (5000 m)
33
Regulatory
USA
FCC Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the distance between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
FCC Class C
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
FCC ID: 2A3FBALPHATRAK3
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the
equipment.
Exposure to Radio Frequency Radiation:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
34