Transportation - Festool KSC 60 EB Original Instructions Manual

English
14
14-3
14-2
14-1
14-1
11.3 Cleaning/replacing the spotlight
window
The spot lighting SL‑KSC60 lights up the cutting
edge on the workpiece. Dust-intensive work
may affect the power of the light. Proceed as
follows to clean the spotlight [15]:
► Move the machine into the working position.
► Pull out the spotlight window [15-1] by
hand, and clean/replace it.
► Reinsert the spotlight window.
The spotlight window audibly clicks into
place.
15
15-1

12 Transportation

CAUTION
Risk of crushing
The saw unit may swing out/extend
► The machine must always be transported
in the transport position that has been pro­
vided for this purpose.
26
CAUTION
Risk of injury!
The power tool may slip out of your hands
when you are carrying it.
► Always carry the power tool with both
hands, using the carrying handles [16] pro­
vided on both sides of the power tool.
12.1 Securing the machine (transport
position)
► Remove the battery pack from the power
tool.
► Move the saw unit into the rear position and
lock it in place using the rotary knob [1-6].
► Swivel the saw unit into a vertical position.
▷ Loosen the star handle [2-6].
▷ Move the saw unit into a vertical posi­
tion.
▷ Tighten the star handle.
► Lock the saw unit in place.
▷ Press and hold the safety button [1-3].
▷ Move the saw unit downwards until it
reaches the limit stop.
▷ Pull the lever for the transport locking
device [1-7].
▷ Release the safety button.
The saw unit remains in the lower position.
► Swivel the rotary base into the right-hand
position.
▷ Release the rotary knob [1-14].
▷ Press and hold the detent lever [1-13].
▷ Swivel the rotary base [1-15] as far to
the right as it will go.
▷ Release the detent lever, close the rota­
ry knob.
The machine is in the transport position [16].
12.2 Carrying handles provided
– Handle on the saw unit [16-1]
– Handle on the key storage box [16-3]
– Extension tables [16-2] (when fixed in
place)