OMFB RADAR II Installation And User Manual page 23

"RADAR II"
USER MANUAL 101-050
IS IT POSSIBLE TO DISABLE THE AUXILIARY SIGNAL WHEN ONE OF THE TWO OR
FOUR OUTPUTS IS ACTIVATED?
Yes, but this operation may be carried out only by the engineers of OMFB SpA Hydraulic
Components, by placing the request directly together with the order, or as a subsequent
alteration, referring to "Single-acting".
IS THERE A VERSION OF THE RADIO REMOTE CONTROL THAT CAN INSTALL AN
EXTERNAL ANTENNA?
No, we did not deem it necessary to develop a product with external antenna, since the
selectivity of the RF module installed on the receiver is high enough to ensure operation
even in critical conditions, near considerable ferrous masses..
IS IT POSSIBLE TO OBTAIN CLEAN CONTACTS IN PLACE OF THOSE THAT REFLECT
THE SUPPLY VOLTAGE?
No, you must use additional controlled relays at the supply voltage, and take the desired
clean contact from these.
ONE OF THE LATEX SAFETY HOODS IS TORN.
Send the receiver to OMFB SpA Hydraulic Components to replace and repair it, since the
absence of these protections reduces the IP protection rating of the apparatus.
DOES THE RADAR II RADIO REMOTE CONTROL REQUIRE ANY MAINTENANCE?
The RADAR II radio remote control requires no maintenance aside from replacing the
transmitter battery. However, it is recommended to keep the receiver clean, especially
removing any deposits of mud or other material that could degrade its performance in the
long run. Do not use hydraulic cleaners.
IS IT POSSIBLE TO INSERT THE RECEIVER INTO AN ADDITIONAL PLASTIC
HOUSING?
Yes, this is not subject to any particular limitations, as long as you are certain that the plastic
of the housing into which the receiver is inserted has a minimal (or no) lead content.
If the problem persists, contact OMFB SpA Hydraulic Components.
pag.47
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it