Table of Contents
Advertisement
"RADAR II"
4.2 Connecting devices to the receiver
A terminal board is used to connect devices (solenoid valves, remote switches) to the
electronic board of the receiver.
In standard versions the radio remote controls are supplied with 1 m of cable, mounting
one or two 5-pin connectors that are described in the next paragraph: the cables used in
the standard versions have a cross-section of 1 mm^2, and the function/color pairing is
as follows:
POSITIVE POWER SUPPLY
NEGATIVE POWER SUPPLY
UP 1
DOWN 1
UP 2
DOWN 2
AUXILIARY
Should it be necessary to make any changes to the connections on the board,
or even to perform simple tests, the connection diagram is shown here below:
however, since the receiver housing must be opened in order to perform this
operation, it MUST be agreed upon by phone with OMFB staff.
USER MANUAL
-
+
UP 1
pag.36
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it
"+"
Red
"-"
Yellow/Green
"UP1"
Black
"DW1" White
"UP2" Brown
"DW2" Purple
"AUX"
Light blue
SPEC: For special applications only
101-050
AUX
DW2
UP2
DW1
spec
spec
spec
Advertisement
Table of Contents
