Table of Contents
Advertisement
"RADAR II"
3. T
ECHNICAL SPECIFICATIONS
3.1 RADAR II Midi transmitter apparatus
(Regarding the RADAR NEW TXF transmitter, consult the enclosed manual)
POWER SUPPLY
ABSORBED CURRENT
SPURIOUS EMISSIONS (vs. BASIC)
WORKING FREQUENCY
TRANSMISSION POWER (E.R.P.)
MODULATION
TRANSMISSION ENCODING
OPERATING TEMPERATURE
TRANSMISSION RANGE (WITH STANDARD RX) 10 mt
3.1.1 Battery Use
The transmitter is standard-equipped with a power supply battery type 6LR61 9 V already
inserted in the compartment provided.
3.1.2 Replacing the Battery
When light of the transmitter LED is weakened, or the command reception capacity
degraded, it is necessary to replace the power battery.
To replace, open the rear cover of the transmitter, remove the used battery and insert the
new one. Finally, close the battery compartment cover, taking care not to damage the
power supply wires.
Warning:
• Remove the battery before disposing of the radio remote control;
• The used battery should be disposed of according to current regulations, by using
the special containers available for this purpose;
• If fluid is leaking from the battery, replace it immediately, making sure to clean
the battery compartment and wash your hands thoroughly in case of contact with
the leaking fluid. Do not allow eyes to come into contact with these substances.
USER MANUAL
pag.34
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it
Battery type 6LR61 9 V
Max 12-15 mA
-50 dB
433,920 MHz
<10 mW
AM
13 bit Digital
- 30 / + 55 °C
101-050
Advertisement
Table of Contents
