Table of Contents
Advertisement
"RADAR II"
• The best reception capacity is obtained by placing the receiver as high as possible
off the ground;
• Whenever possible, the receiver should be clearly visible from the transmitter
work area.
• The field radiates concentrically from the antenna; in the case of receivers without
external antenna, the latter is aligned with the receiver box.
As already mentioned in the previous paragraph:
The power supply line (+12/24V batt and ground) should lead to the receiver directly from
the main source (battery or stabilized power source), with cables adequately sized for the
load to be carried (cross-section of at least 1 mm^2), also using a safety fuse.
The power supply line to the receiver must be kept locked, or under a switch dedicated
specifically to the radio remote control system, or under an appropriately sized battery
disconnector.
It is essential that the radio remote control system never be powered while the
vehicle is running: the installer is responsible for informing the system end user
of this fact.
5.2 Positioning the receiver
Install the receiver with the cable input facing down, never upwards.
TOP
UPPER SIDE
5.3 Fastening the receiver
To fasten the receiver you must take advantage of the studs already present on the receiver
box. Do not drill any holes in the box, under penalty of voiding the product warranty.
USER MANUAL
pag.40
O.M.F.B. S.p.A. Hydraulic Components
We reserve the right to make any changes without notice.
Edition 2003.06 No reproduction, however partial, is permitted.
Via Cave, 7/9 25050 Provaglio d'Iseo (Brescia) Italy Tel.: +39.030.9830611
Fax: +39.030.9839207-208 Internet:www.omfb.it e-mail:contatti@omfb.it
101-050
Advertisement
Table of Contents
