Step 8 Safety Check - Niles Remote Control Anywhere Kit Operation Manual

INSTALLATION
Step 8
Safety Check
Once you have found your
installation spot, locate
nearby studs in the wall with
a stud sensor or by hand
knocking.
When you've found a
location that is free of studs,
drill a small 1/8" pilot hole
just barely through the
drywall. (See Figure 11)
Be careful. If you feel any
!
extra resistance as you
are drilling. STOP!
Cut a piece of coat hanger
and bend the wire to create
two right angles opposite of
each other about four inch-
es long. Poke the four inch
end of the "Z-shaped" wire
into the pilot hole and rotate
in a complete circle while
probing the inside of the
wall for obstructions.
If the wire's movement is
obstructed by a pipe, cable
or wall stud, fill the hole with
spackle or other patching
compound, sand, paint and
try another location.
CONTINUED
yyyyyyy y y y yy y y
Figure 11
yyyyyyy
yyyyyyy
13
y