Mounting A Microflasher To A/V Components - Niles Remote Control Anywhere Kit Operation Manual

INSTALLATION
CONTINUED
Step 5 Figure 6
Mounting a
MicroFlasher to A/V
Components
Make sure all of your remote
controls have batteries and
that they are able to operate
the A/V components.
Locate a place for the
remote control that is within
arm's length of the A/V
components, yet cannot
directly control them. Place
the Wall-Mount Sensor no
closer than two feet in front
of the remote control.
(See Figure 6)
Hold the MicroFlasher four
inches in front of the remote
sensor window on the A/V
component's front panel.
Press buttons on the remote
control while watching the
front panel of the A/V com-
ponent. When the compo-
nent responds repeatedly to
the commands, peel off the
protective backing on the
MicroFlasher and place the
MicroFlasher in that location.
continued
9