Dremel 4300 Operating/Safety Instructions Manual page 37

Find Quality Products Online at:
Sanding/Grinding Guide Attachment Model A576
Read the tool manual
and these instructions
for the use of this accessory with your tool.
Failure to follow all instructions listed below
may result in serious personal injury.
Do not use Dremel
chuck
attachment. Only use a collet and collet
nut.
For use with 1/2" or less
sanding and grinding stone
accessories only.
The guide comes completely assembled and
ready to use for sanding and grinding
applications up to ½" ( 13 mm) thick.
Router bits are not allowed
for use
Sanding/Grinding Guide attachment.
Sanding/Grinding Guide Attachment
Installation instructions:
1. Remove the nose cap A from the end of
the tool and set nose cap aside. The
original nose cap must be reinstalled when
this attachment is not used (Fig. E1).
2 Loosen the collet nut and place your
accessory in and tighten. Note: The
attachment is for ½" diameter accessories
or smaller. Please refer to the Rotary tool
instructions manual for proper collet nut
assembly instructions and accessory
operation instructions.
When inserting a bit into
your Dremel Rotary Tool
be sure that the bit is securely inserted into the
collet. Always use the wrench to tighten the
collet nut to prevent the bit from loosening
within the collet.
3. Thread the attachment B onto the threaded
portion of the housing collar C (Fig. E2).
4. Adjust the attachment B to the desired
depth by loosening the wing knob D (Fig.
E3).
Using the Sanding/Grinding Guide
Attachment
The guide has a 90 and 45 degree bevel for
various sanding applications. The tool with the
guide attached can be taken to a secure work
piece or can be stationary in the Dremel Multi-
Vise.
GlobalTestSupply
www.
FIG. E1
with this
A
FIG. E2
with the
B
FIG. E3
FIG. E4
B
FIG. E5
C
B
D
F
E
37
.com
sales@GlobalTestSupply.com