Dremel 4300 Operating/Safety Instructions Manual page 12

Find Quality Products Online at:
BALANCING ACCESSORIES
For precision work, it is important that all
accessories be in good balance (much the
same as the tires on your automobile). To true
up or balance an accessory, slightly loosen
chuck or collet nut and give the accessory or
collet a 1/4 turn. Re tighten the chuck or collet
nut and run the Rotary Tool. You should be able
to tell by the sound and feel if your accessory is
running in balance. Continue adjusting in this
fashion until best balance is achieved. To
maintain balance on abrasive wheel points,
before each use, with the wheel point secured
in the collet, turn on the Rotary Tool and run the
415 Dressing Stone lightly against the revolving
wheel point. This removes high spots and trues
up the wheel point for good balance.
Model No. Description
220 Workstation drill press
225 Flex Shaft
335-01 Plunge Router
A550 Shield
565 Multipurpose cutting kit
575 Right angle attachment
670 Mini Saw attachment
A679-02 Sharpening kit
231 Router Table
A576 Sanding/Grinding Guide
490 Dust Blower
577 Detailers Grip
678-01 Circle cutter / straight edge guide
Do not use router bit with the Dremel chuck. Bit may become a projectile
and cause serious injury.
12
GlobalTestSupply
www.
4300 Attachment Compatibility
Dremel rotary tool attachments allow you to
change the function of your tool so that it is
more optimized for your application. You can
find the full line of Dremel rotary tool
attachments. The Dremel
compatible with all currently
Dremel attachments. Depending on the
attachment being used, you will either need to
use a collet and collet nut to hold the accessory
or will be able to use the Dremel Chuck to hold
the accessory. The following chart shows
which attachments function with the Dremel
Chuck. For more information on individual
attachments, please refer to the user manual
for those attachments in this manual or that
came with those attachments.
Dremel chuck
compatible? Comment
Yes
Chuck fits on the
Yes output shaft of the
Flex Shaft
No Collet is required
Yes
No Collet is required
Chuck fits on the
output shaft of the
Yes
right angle
attachment
N/A
No Collet is required
No Collet is required
No Collet is required
No Collet is required
Yes
No Collet is required
.com
4300 is
available
sales@GlobalTestSupply.com