Dremel 4300 Operating/Safety Instructions Manual page 26

Find Quality Products Online at:
EZ Drum
EZ Drum™ Mandrel No. EZ407SA has a
spring loaded sleeve and is used with
Always make sure the
sanding bands.
rotary tool is "OFF" and
disconnect the plug from the power
source or the battery pack from the tool
before changing accessories. Such
preventative safety measures reduce the risk
Always make sure accessory is properly
of starting the power tool accidentally.
seated on mandrel before use. Incorrect
seating of accessory on mandrel may lead to
To load accessory:
personal injury or property damage.
1. As indicated, place two fingers underneath
the mandrel and pull firmly up. This will
place the EZ Drum™ in the "unlocked"
position (Fig. 1).
2. Keeping two fingers beneath the mandrel,
slide the sanding band down until the
entire blue mandrel is covered (Fig. 2).
3. To return to "locked" position, press firmly
Removing the sanding band on
down on the top of the mandrel (Fig. 3).
the mandrel:
1. Place two fingers underneath the mandrel
and pull firmly up. This will place the EZ
Drum™ in the "unlocked" position (Fig. 1).
2. Sanding band will now easily slide off
mandrel (Fig. 2). Do not squeeze sanding
band when removing from EZ Drum™
mandrel. This can lead to rubber band
pulling off mandrel and becoming
inoperable.
26
GlobalTestSupply
www.
Operating Instructions
™
FIG. 1
FIG. 2
FIG. 3
.com
sales@GlobalTestSupply.com