ElectroSteam IND00105 Use And Maintenance Manual page 42

8
- MAINTENANCE
This machine is equipped with a
system of bleeding hydraulic
circuit of charging boiler, so
that storage at low
temperature, reducing the risk
of damage that may cause the
ice.
Never store the machine at
temperatures below 0° C,
without first following the steps:
1) release the green button
(green light switches off).
2) press the white button (the
white indicator light should
come on).
3) dispense steam until the
pressure gauge marks 0 bar
and wait until the cooling
machine.
4) open the boiler drain tap.
5) empty the water tank.
6) drain the detergent tank.
7) press the extract button for
about 15 seconds on the
cleaner gun (maximum 20
seconds)
8) press the black button on the
side of the charging circuit
emptying, electrical panel, for
15 seconds (maximum 20)
9) wait for emptying the boiler
10) close the drain.
Caution: the drain must be
opened only when the boiler is
cold.
Note: the black button to
empty the charging circuit is
active only when the green
button is deactivated (green
led off), remember to always
open the drain.
English
Execute this procedure only
with machine cooled down
and completely un-pressuri-
zed (pressure gauge pointer
on the "0" position (Fig. 27).
If the machine is not used for
long periods of time, be sure
not to leave water in the tank
to avoid the formation of al-
gae and calcareous deposits.
41
Steam Master