ElectroSteam IND00105 Use And Maintenance Manual page 31

The signal lamp (1-Fig.4) on the
control panel indicates correct
machine feeding.
Turn on the general switch for
pump-heater feeding (3 Fig.4):
the temperature display (4 Fig.4)
will blink for about 4-5 seconds
and will then stabilize indicating
the internal boiler temperature.
Low water level in the tank is
indicated by the no-water si-
gnal lamp (2) and an acoustic
signal.
The signal lamp (2 Fig.4) will turn
on for 2 about seconds and
then will turn off.
When a temperature of about
180° is reached (visible on display
4 Fig.4) along with a pressure
value of about 10 bar (pressure
gauge 2 Fig. 2), the machine is
ready to deliver vapor.
If water is running low in the
tank, the no-water signal lamp
(2 fi g.4) will start blinking along
with an acoustic signal.
On the rear of the machine the
two tanks for water and deter-
gent are easily visible. (Fig. 5)
Fill the tank with running water
as indicated in Fig. 6. When
the minimum water level is rea-
ched, the signal lamp and the
acoustic signal are turned off.
(2 - Fig. 4)
When water refi lls the boiler, the
signal lamp (2 - Fig.4) is turned
on with no acoustic signal.
DO NOT fi ll the water tank with
liquids other than simple run-
ning water.
The non compliance with this
note could affect the proper
operation of the generator.
English
Fig. 4
Fig. 5
29
Fig. 6