ElectroSteam IND00105 Use And Maintenance Manual page 40

8
- MAINTENANCE
Execute this procedure only
with machine cooled down
and completely un-pressuri-
zed (pressure gauge pointer
on the "0" position (Fig. 27).
NOTE:
The best time to clean the
probes is after the Steam
Generator has been given a
fair amount of time to cool.
If the machine is not used for
long periods of time, be sure
not to leave water in the tank
to avoid the formation of al-
gae and calcareous deposits.
It's possible to drain water
from the boiler to remove and
expel any calcareous residues.
To do so, open the tap located
under the control panel.
(Fig. 26)
Be sure to close the tap once
water is completely drained.
English
The Boiler Water Level Probe and the heating
elements are the two main components that cause
the most malfunctions.
CLEANING the PROBE a n d H E A T I N G
E L E M E N T S i s b y f a r t h e MOST IMPORTANT
maintenance step to keep your generator running
properly.
The probe and heating elements should be cleaned at
least FOUR TIMES A YEAR or 500 HRS.
Fig. 26
38
Fig. 27