Enerpac PRV-8 Instruction Sheet

POWERFUL SOLUTIONS. GLOBAL FORCE.
L3062 Rev. A
Index:
English ............................................ 1-4
Français ..........................................N/A
Deutsch ..........................................N/A
Italiano ............................................N/A
Español ...........................................N/A
Nederlands .....................................N/A
Portuguese .....................................N/A
...............................................N/A
Repair Parts Sheets for this product are available
from the Enerpac web site at www.enerpac.com,
or from your nearest Authorized Enerpac Service
Center or Enerpac Sales offi ce.
1.0 IMPORTANT RECEIVING
INSTRUCTIONS
Visually inspect all components for shipping
damage. Shipping damage is not covered by
warranty. If shipping damage is found, notify
carrier at once. The carrier is responsible for
all repair and replacement costs resulting from
damage in shipment.
SAFETY FIRST

2.0 SAFETY ISSUES

avoid personal injury or property damage during
system operation.
responsible for damage or injury resulting from
unsafe product use, lack of maintenance or
incorrect product and/or system operation.
Contact Enerpac when in doubt as to the safety
precautions and operations. If you have never
been trained on high-pressure hydraulic safety,
consult your distribution or service center for a
free Enerpac Hydraulic safety course.
05/11
Read all instructions,
warnings and cautions
carefully. Follow
safety precautions to
Enerpac cannot
PRV-8, PRV-9 PRESSURE REDUCING VALVES
Failure to comply with the following cautions
Page
and warnings could cause equipment damage
and personal injury.
A CAUTION is used to indicate correct
operating or maintenance procedures and
practices to prevent damage to, or destruction
of equipment or other property.
A WARNING indicates a potential danger that
requires correct procedures or practices to
avoid personal injury.
A DANGER is only used when your action or
lack of action may cause serious injury or even
death.
during operation.
personal injury. The pressure reducing valve is
designed for a maximum operating pressure of
350 bar [5000 psi]. Do not use the valve in
circuits where higher pressures are present.
settings may result in equipment damage and/
or personal injury. Do not remove relief valve.
all
be
component in the system. Install pressure
gauges in the system to monitor operating
pressure. It is your window to what is happening
in the system.
1
Instruction Sheet
PRVM-2 MANIFOLD
WARNING: Wear proper personal
protective gear
hydraulic equipment.
DANGER: To avoid personal
injury keep hands and feet away
from cylinder and workpiece
WARNING: Do not exceed equipment
ratings. Overloading
equipment failure
DANGER: Never set the relief valve to
a higher pressure than the maximum
rated pressure of the pump. Higher
WARNING: The system operating
pressure must
pressure rating of the lowest rated
when operating
causes
and possible
not exceed the