Table of Contents
Advertisement
Connect One
To test the connection, use the iChipConfig utility to perform any activity that
requires network connection such as retrieving a web page, sending an email, or
opening a socket. You may also try to PING the iChip from another station on the
network.
7.
Additional Connections
The modules support two additional connections:
SPI Slave
The modules support an alternative Host interface to the RS232 Serial port and the
USB connection. A host equipped with an SPI Master connection may connect to the
module's SPI Slave port and interact with the module with AT+i commands.
An SPI cable (not supplied) connects to the II-EVB-363 J3 SIP connector:
A full description of interfacing the modules with SPI is included below in Appendix
5.
RJ45 10/100BaseT Ethernet LAN (for Nano WiReach/Socket iWiFi)
The II-EVB-363 contains a standard 10/100BaseT RJ45 connector that allows a direct
connection to a wired LAN. The use for this connection is to implement a WiFi to
LAN bridge with the Nano WiReach/Socket iWiFi module. The bridge feature is
supported in Nano WiReach/Socket iWiFi firmware version 8.04 or later.
II-EVB-363NW User's Manual
nSPI_INT
nSPI MISO
nSPI MOSI
nSPI_CLK
nSPI_CS
GND
J3
7
Advertisement
Table of Contents
