Advertisement
Installing the Roller Brush
Assembly
1.
Remove the grease fitting for the roller from the
side of the cutting unit that has the roller-brush
housing
(Figure
7).
1. Grease fitting
2.
Install the 90° grease fitting so that it faces
rearward
(Figure
1. Spacer
2. Side-plate mounting flange 4. Flange locknuts and
3.
Remove the 2 flange locknuts and washers
securing each roller bracket to the side plates
(Figure
8).
Note:
Do not remove the bolts. Also, remove
any spacers positioned on the top side of the
side-plate mounting flange.
4.
Position the left or right roller-brush assembly
mounting brackets onto the roller-bracket bolts
(Figure
9).
Figure 7
8).
Figure 8
3. Grease fitting (90°)
washers (remove them)
g031872
1. Left roller-brush assembly
2. Roller-brush mounting
bracket
Important:
mounting brackets directly to the top surface
of the cutting-unit side-plate mounting
flange. Do not put spacers between the
roller-brush mounting brackets and the
side-plate mounting flanges. Save the
additional spacers for potential later use.
5.
Secure the brush-assembly mounting brackets
to the cutting-unit side plates with the nuts and
washers that you previously removed.
g031873
4
Figure 9
3. Washer (4)
4. Flange locknut (4)
Mount the roller-brush assembly
g037641
Advertisement
