Advertisement
Figure 3
1. Roller-brush housing
2.
For Model 133-0158 kit for Reelmaster
5010 machines with 7-inch cutting units
only: Mount the roller-brush housing to the
reel-bearing housing with 2 hex-socket bolts (3/8
x 1 inch); refer to
Note:
Position the roller-brush housing so that
the threaded hole is toward the front of the
cutting unit.
Figure 4
1. Roller-brush housing
2. Threaded hole
3.
For Model 133-0157 kit for Reelmaster 5010
machines with 5-inch cutting units only:
•
For a hydraulic-driver reel motor: Install
2 bolts (5/16 x 1/2 inch) on the top of the
roller brush housing as shown in
(hydraulic 5-inch reel motors only).
2. O-ring
Figure
4.
3. Hex-socket bolt
4. Front of the machine
Figure 5
g020371
1. Order 1 weight (Part No.
127-4259-03) and 2 bolts
(Part No. 322-7) for the
electric reel motor.
2. Bolts (5/16 x 1/2 inch) for
the hydraulic reel motor
•
For an electric-driven reel motor: Order
and install 1 weight (Part No. 127-4259-03)
and 2 bolts (Part No. 322-7) as shown in
Figure
Note:
kit are not used.
Note:
machine with a 5-inch or 7-inch cutting
unit with an electric-driven reel motor: On
the reel motor side plate, replace the front
side plate shoulder bolt with a flange hex
socket shoulder bolt as shown in
g037640
Reel Motor Side of Cutting Unit
1. Front side plate shoulder
bolt (remove and discard)
3
Figure 5
3. Roller-brush housing
5.
The 2 bolts (5/16 x 1/2 inch) from the
For the Reelmaster 5010-H
Figure 6
2. Flange hex socket
shoulder bolt (new)
g028040
Figure
6.
g035933
Advertisement
