Quick Guide To Custom Settings Options - Nikon D1 Manual

31. Sensitivity Up
By default, sensitivity can be set to a values equivalent to ISO 200, 400,
800, or 1,600. Sensitivity up can be used to increase sensitivity by a factor
of +1 or +2 over ISO 1600. These settings can be used to achieve high
shutter speeds at night-time sporting events, or to achieve optimal expo-
sure when taking photographs of poorly-lit subjects. Note, however, that
high sensitivity settings increase the amount of noise that appears in the
final photograph. It is recommended that you take a trial photograph to
check the results when shooting at high sensitivity settings.
Option: 0 Sensitivity can be set to values equivalent to 200, 400, 800, or
1,600 (default)
1 Sensitivity set to +1 (sensitivity display in rear control panel
shows HI-1)
2 Sensitivity set to +2 (sensitivity display in rear control panel
shows HI-2)

Quick Guide to Custom Settings Options

Copy the following table and keep it with your camera for reference.
Custom Setting Option
A
0: Custom settings
b
0
1
1: Image status
Record-and-Review
2
3
2: EV steps for
exposure 2
control
1
0
3: Bracketing
order
1 Negative-to-positive
0
4: Autofocus
activation
AF activated by
1
0
5: Anti-vibration
mode
1
0
6: Focus area
selection
1
0
7: AE lock
1
74
Meaning Custom Setting
Custom Set A
8: Mirror up
Custom Set B
Disabled
9: Dynamic AF
Capture Preview
mode (single-
Mode
servo AF)
Mode
10: Dynamic AF
1
/
mode (continu-
3
ous-servo AF)
1
/
2
1
Default 11: Auto exposure/
flash exposure
bracketing
Shutter-release
button activates AF
12: Command dial
button only
functions
Disabled
Enabled
13: Exposure
Default
compensation
Wrap-around
settings
Only button
locks AE
AE locks when
shutter-release
button pressed half
way
Custom Settings: Custom Settings Options
Option Meaning
0 Mirror down
1 Mirror up
Closest subject
0
priority enabled
Closest subject
1
priority disabled
Closest subject
0
priority disabled
Closest subject
1
priority enabled
Flash and auto
AS
exposure
AE Auto exposure only
Sb Flash exposure only
0 Default
Roles of main and
1 sub command dials
reversed
0 Default
Exposure compen-
sation set by turning
1
main or sub com-
mand dial