Advertisement
INSTALL GUIDE
Page 11 of 12
1
LED fl ashes (1X) once = DATA MODE
LED fl ashes (2X) twice = STANDARD HARDWIRE MODE
1
2
!
Place all other keyfobs at least 1 foot away from the
Weblink HUB. Failure to comply may result in damage
to other keyfobs or interfere with the keyfob reading
process.
3
WWW.IDATALINK.COM
Patent No. US 8,856,780 CA 2759622
ADS-AL(AL)-SUB9-EN
INSTALLATION MODE SELECTION
Press and release
programming button
to select installation mode.
MODULE PROGRAMMING PROCEDURE - PUSH TO START
For this installation, the Weblink
HUB is required.
Remove OEM key 1 from
keychain.
Flash the module using the
Weblink HUB. Follow the on
screen instructions to complete
the keyfob reading process.
2
!
After registration, follow Factory Reset Procedure to
change installation mode and restart this procedure.
4
Æ
5
ON
6
7
OFF
8
ALL IN ONE
Subaru
20221206
Doc. No.: ##80972##
Press and hold
programming button
until LED turns solid GREEN
to register selection.
WARNING:
Do not press the module
programming button.
Connect power fi rst.
Connect module to vehicle.
Using OEM key 1, turn key to ON
position.
Wait, LED will turn solid GREEN
for 2 seconds.
Turn key to OFF position.
Module Programming
Procedure completed.
Automotive Data Solutions Inc. © 2022
Advertisement
