Table of Contents
Advertisement
2.
Slide threaded end of hand lever through
opening in side of hand lever clutch (see
Figure 7). Secure with 13mm fender
washer, 25 x 28mm compression spring,
19mm fender washer, and M10-1.5 hex nut.
Tighten hex nut until spring compresses
about
⁄
".
7
8
Compression
Spring
Hex
Nut
Figure 7. Hand lever installed.
3.
Raise headstock to highest point and secure
with depth stop knob, as shown in Figure 8
(see Adjusting Depth Stop on Page 23).
Depth
Stop
Collar
Figure 8. Depth stop securing headstock at
highest position.
-16-
Hand Lever
13mm
19mm
Washer
Washer
Depth
Stop
Knob
4.
Secure
work
(2) M8-1.25 x 20 flat head screws (see
Figure 9).
Figure 9. Work table secured to base.
5.
Slide 33 x 80mm compression spring onto
fence rod. Then slide fence rod through
guide block (see Figure 10).
Fence
Rod
Fence
Collar
Figure 10. Fence installed.
Model T33127 (Mfd. Since 10/21)
table
to
base
using
Guide
Block
Compression
Spring
Advertisement
Table of Contents
