Warning Level (Default Version) - Kubota B2650HSDC Workshop Manual

B2650HSDC, B3350HSDC, WSM

(6) Warning Level (Default Version)

PM warning level 0 to 5 as shown below is programmed according to the amount of accumulated PM to prompt
the operator to perform the required procedure in each level.
• Level 0: Normal operation. Regeneration is not required.
• Level 1: Auto Regeneration is possible in the Auto Regeneration Mode.
• Level 2: Auto Regeneration is possible in the Auto Regeneration Mode. Parked Regeneration is possible in both
of the Auto Regeneration Mode and Inhibit Mode.
• Level 3: Auto Regeneration is not possible in above level 3. Parked Regeneration is required as soon as possible.
• Level 4: Only by using diagmaster, Parked Regeneration is possible. Parked Regeneration is required as soon
as possible.
• Level 5: Replacement is required. Regeneration is not possible.
Auto Regeneration Mode
Engine
Warning
Buzzer output
level
limitation
No
0 No
limitation
No
1 No
limitation
Every 5
2-1
seconds
No
limitation
Every 3
2-2
seconds
Every
3 50 %
second
Every
4 50 %
second
Every
5 50 %
second
 : OFF,  : Blink,  : ON
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
   
1-M18
Remark
Normal operation, Regeneration is not required.

Under the Auto Regeneration or preparation for Auto

Regeneration.
Initiation condition for Regeneration is not satisfied.
(Coolant temperature and Voltage are below threshold.)
Keep on working and increase the engine rpm until

regeneration indicator stops flashing and remains constant
"ON".
Under the Auto Regeneration or preparation for Auto

Regeneration.
Initiation condition for Regeneration is not satisfied.
(Coolant temperature and Voltage are below threshold.)
Keep on working and increase the engine rpm until

regeneration indicator stops flashing and remains constant
"ON".
Condition for Parked Regeneration is not satisfied.

Condition for Parked Regeneration is satisfied. When
pressing the parked regeneration switch, Parked

Regeneration will start.
Under the preparation for Parked Regeneration.

Initiation condition for Regeneration is not satisfied.

(Coolant temperature and Voltage are below threshold.)
Under the Parked Regeneration.

Without diagmaster.

Condition for Parked Regeneration is not satisfied.

Condition for Parked Regeneration is satisfied. When
pressing the parked regeneration switch, Parked

Regeneration will start.
Under the preparation for Parked Regeneration.

Initiation condition for Regeneration is not satisfied.

(Coolant temperature and Voltage are below threshold.)
Under the Parked Regeneration.

Even when using diagmaster, it is not possible to do Parked

Regeneration.
ENGINE
9Y1210822ENM0037US0
9Y1210822ENM0038US0
KiSC issued 05, 2014 A