Invacare 1600 Bed User Manual page 10

e . Safety Rail:
There is a risk of entrapment on assembly and operation of safety sides.
1. Raise the bed about one third.
2. With the release knob at the head end, position safety
side brackets against the bed frame such that in the
lowered position the safety side does not go past the
head of the bed.
3. Press fit onto bed frame, attach flat bar and tighten the
star knob for secure holding.
f . Bumper Bar:
The bumper bar fits both Standard and Knee Break Beds.
Installation
1. Apply wheel brakes on bed.
2. Plug bed into power.
3. Using handset controls, lift mattress base to its
highest position.
4. Holding the bumper inverted, line up both labels
with holes in the end of base frame.
5. Slide the bumper into the frame, at Head End of the
Bed Base, until the locating pins click into the holes,
approximately 100mm.
Removal:
1. To remove the bumper, apply wheel brakes on bed.
2. Squeeze both sides of locating pins to disengage bar
from holes.
3. Squarely pull the bumper out of the bed's base frame.
All information is subject to change without prior notice. Photographs are for illustration purposes only and may vary from product description.
Invacare® is a registered trademark and Yes, you can.™ is a trademark of Invacare® Corporation. 2010 Invacare Asia Pacific
1600 User's Manual
10
Safety side brackets
Raise bed about one third
Bumper bar
Bumper bar