Napoleon DYNAMIC LV38N-1 Installation Manual page 10

Dynamic Heat Control™ installation
EN
a
b
4.) Bend the sides of the defl ectors as shown.
FOR LV38-1 / LV62
5.) Secure defl ectors to the appliance with supplied fasteners as
shown.
6.) Re-install front frame using the fasteners removed in step 1.
WARNING
!
FOR SEE-THRU APPLIANCES, REPEAT STEPS WITH THE FIXED SIDE.
IMPORTANT:
It is recommended to install venting and vent heat shield(s) before refi tting the
front, (and where applicable rear), frame for ease of access. It is critical for see-thru
appliances that ALL 4 knockout plates, ALL 4 cover plates are removed and ALL 4
defl ectors are installed.
10
W415-2373 / B / 04.30.21
FOR LV50-2 / LV74
5.) Remove outer knockout fasteners. Do not discard
fasteners.
6.) Secure defl ectors to the appliance with fasteners removed in
step 5 and supplied fasteners.
7.) Re-install front frame using the fasteners previously used
in step 1.