Hytek ALPHA/50WAFC Technical Data Manual page 9

FUELLING FROM THE ALPHA PUMP TERMINAL
THE FUELLING PROCEDURE:
a.) Insert Data Tag into the Data Tag Reader Slot. The display will show
the Data Tag ID number and the registration number of the vehicle the
Data Tag is allocated to.
b.) If a message for the vehicle user is stored on the system, it will be
displayed.
acknowledge the message, before fuel can be drawn.
c.) If entry of the vehicle's odometer reading is required, the display will
show "PLEASE ENTER CURRENT ODOMETER". The last odometer
reading entered for this vehicle will also be shown if this feature has
been enabled in the Fuel Manager software. Type the current vehicle
odometer reading, on the keypad, followed by pressing the "ENT" key.
d.) If entry of a driver's identity PIN number is required, the display will
show "PLEASE ENTER DRIVER ID". Type the identity PIN number of
the driver, on the keypad, followed by pressing the "ENT" key.
e.) "REMOVE DATA TAG" will be shown on the display.
f.) Remove the Data Tag from the Data Tag Reader Slot. The display will
now show "PLEASE FUEL AT THE PUMP".
g.) Remove the nozzle from the pump nozzle holster, place in the vehicle
fuel tank filler and draw fuel.
h.) The amount of fuel dispensed will be shown on the display.
i.) On completion of the fuel delivery replace the nozzle in the pump
nozzle holster.
j.) The amount of fuel taken will be retained on the display screen until a
Data Tag is inserted into the Data Tag Reader Slot.
The "ENT" key on the keypad must be pressed, to
S886/3