1.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting brackets to the controller
with the included 8 mm M4 screws.
Figure 5 Attaching mounting brackets
WARNING!
to attach the mounting brackets to the controller.
NOTE:
for a wide variety of mounting options. These include mounting the controller so that its front
face is flush with the face of the rack, or mounting it in a more balanced position.
2.
Hold the controller with attached brackets up to the rack and move it vertically until rack holes
line up with the bracket holes, then insert and tighten the four number 12-24 screws holding
the brackets to the rack.
Figure 6 Mounting in a rack
Wall mounting
WARNING!
down.
CAUTION:
(1/2 inch) plywood or its equivalent.
1.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting brackets to the controller
with the included 8 mm M4 screws.
For safe reliable installation, only use the screws provided in the accessory kit
The mounting brackets have multiple mounting holes and can be rotated allowing
The network ports must be facing up. Do not mount the controller with ports facing
The controller should be mounted on a wall or wood surface that is at least 12.7 mm
Installation procedures
1 1