Advertisement
2. Put a cup underneath the cup stand.
3. Insert empty POD Holder.
4. The display will read "Please Select
"(Fill) (Drain) (X)"
5. Press the Mild button to fill the heat
exchange. When there is a steady stream of
water push any button to cancel this function.
The heat exchange is full and ready to use.
Note:Heat exchanger and coil holds
approximately 30 ounces of water
Note: If the POD holder is not inserted within 20
seconds the program will default back to its
original setting and the process will have to be
started over again.
Interpreting The Display:
The LCD has two lines of information. First Line
is the programming function. Second line is the
programming interface. Each symbol or word has
a corresponding button to interact to that specific
step and they are:
Example:
Line 1 = Temperature
Line 2 = Programming buttons
Push Mild Button to decrease temperature
Push Classic Button to finish editing temperature
Push Dark Button to increase temperature
Puch Hot Water Button to exit
Please Select
Line 1
(Fill) (Drain) (X)
Line 2
Line 1
Line 2
Decrease
Down
Fill
Temperature
(
)(DONE)(
)
-
+
Edit
Increase
or
or
or
Cal.
Up
(X)
Exit
3
Advertisement
