Advertisement
7. Insert three soldered wires to Shrinking Tubes
Finally, you get three soldered wires attached to coils. Insert those soldered wires
into shrinking tubes for insulating.
9. Inserts Shaft Holder to Stator as it shown below
Shaft Holder
Magnet wires
10. A drop of Loctite to copper sleeves or ball bearings and insert them into
shaft holder.
Bearing
Magnet Wires
Note: Make sure lubricant is added to inside of copper sleeves before run the motor.
11. Slot Main Shaft Holder to the Main Shaft
Komodo Hobby
www.komodohobby.com
Shaft Holder
Stator
A drop of Loctite
Bearing
7
Advertisement
