Download Print this page

komodo KH-278 Building Instruction page 5

Outrunner motor standard kit

Hide thumbs Also See for KH-278:

Phase 1

Step (1): Remain 7-8cm long magnet wire for connection use afterward.

Use magnet wire "S1" to start to wind 13 times in clockwise direction at

tooth No.1. Wind from the hub to the outer edge of hammerhead then

back to the hub.

Step (2): Jump to tooth No. 4 and start to wind 13 times in clockwise direction as

step (1).

Step (3): Jump to tooth No. 7 and start to wind 13 times in clockwise direction as

step (2).

Step (4): Cut the magnet wire "S1". This ending of wire will be called "E1" in the

following steps. Note: Remain 7-8cm long magnet wire for connection

use.

Phase 2

Step (5): Remain 7-8cm long magnet wire for connection use afterward.

Use magnet wire "S2" to start to wind 13 times in clockwise direction at

tooth No. 2. Wind from the hub to the outer edge of hammerhead then

back to the hub.

Step (6): Jump to tooth No. 5 and start to wind 13 times in clockwise direction as

step (5).

Step (7): Jump to tooth No. 8 and start to wind 13 times in clockwise direction as

step (6).

Step (8): Cut the magnet wire "S2". This ending of wire will be called "E2" in the

following steps. Note: Remain 7-8cm long magnet wire for connection

use.

Komodo Hobby

www.komodohobby.com