Advertisement
3. Insert main shaft to the center hold of bell
Drop a thick CA glue to the position of main shaft as it shown below. Then insert
the whole front part of main shaft through the Bell carefully.
4. Winding
It is an example of using three individual magnet wires to complete a 3-phases
system. We recommend beginners to wind 12turns for their first motor. For
experienced motor builder, they can wind more or less turns to get different
potential power. Note: Since the last turn is not a complete circle, you need to
wind 13 times to get 12turns' power. Make sure that every coil has the same
number of windings.
E2
E1
Komodo Hobby
www.komodohobby.com
A drop of thick CA
Front Part of Main Shaft
S1
E3
1
9
8
7
6
Diagram of winding system of 9-pole stator
S2
2
S3
3
4
5
Bell
Magnets
3
Advertisement
