Related Manuals for komodo KH-278
Summary of Contents for komodo KH-278
- Page 1 Komodo Hobby Building Instruction & Manual KH -278 Outrunner Motor Standard Kit & KH -278 Outrunner Motor Advance Kit...
- Page 2 Introduction Congratulations on your purchase of KH-278 Outrunner Motor Standard Kit or KH- 278 Outrunner Advance Kit. This outrunner motor kit includes all parts that you need to build a powerful motor for your RC plane. In this kit, most of main parts, bell, shaft holder, main shaft and sleeve, are manufactured by high-end CNC machine.
- Page 3 Komodo Hobby www.komodohobby.com 1. Marks “X” onto magnets First, place all magnets together as a stack. Use marker to mark “X” on the top of magnet until all 15 magnets are marked. This step can make sure all magnets will be placed in NSNSNSNSNSNS magnetic pattern in step 2.
- Page 4 Komodo Hobby www.komodohobby.com 3. Insert main shaft to the center hold of bell Drop a thick CA glue to the position of main shaft as it shown below. Then insert the whole front part of main shaft through the Bell carefully.
- Page 5 Komodo Hobby www.komodohobby.com Phase 1 Step (1): Remain 7-8cm long magnet wire for connection use afterward. Use magnet wire “S1” to start to wind 13 times in clockwise direction at tooth No.1. Wind from the hub to the outer edge of hammerhead then back to the hub.
- Page 6 Komodo Hobby www.komodohobby.com Phase 3 Step (9): Remain 7-8cm long magnet wire for connection use afterward. Use magnet wire “S3” to start to wind 13 times in clockwise direction at tooth No. 3. Wind from the hub to the outer edge of hammerhead then back to the hub.
- Page 7 Komodo Hobby www.komodohobby.com Star (wye) system Solder E1, E2 & E3 Together Delta System Solder Solder Solder E3 to S1 E1 to S2 E2 to S3...
- Page 8 Komodo Hobby www.komodohobby.com 7. Insert three soldered wires to Shrinking Tubes Finally, you get three soldered wires attached to coils. Insert those soldered wires into shrinking tubes for insulating. 9. Inserts Shaft Holder to Stator as it shown below Stator...
- Page 9 Komodo Hobby www.komodohobby.com 12. Put M3 Washer and Slot a C-clip to the end of main shaft to secure whole motor system. C-clip M3 Washer Congratulation! You finished the assemble work of your unique outrunner motor. You can install this outrunner motor to Shock Flyers, Park Flyers or RC Indoor Planes.