Assembling The Hand Vacuum; Removing And Fitting The Battery - Stihl SEA 20.0 Instruction Manual

7 Assembling the Hand Vacuum

6.3 Displaying State of Charge
1
► Insert battery.
► Press the button (1).
The LEDs emit green light for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.4 LEDs on the hand vacuum
The LEDs can indicate the state of charge of the
battery or any faults. The LEDs can be steady
green, steady red or flashing.
If the LEDs are steady or flashing green, this
indicates the state of charge of the battery.
► If the LEDs glow or flash red: Troubleshooting,
17.1.
Malfunction in hand vacuum or battery.
6.5 LED on Charger
The LED indicates the operating status of the
charger or faults. The LED can glow or flash
green or red.
If the LED glows or flashes green, the battery is
being charged.
► If the LED glows or flashes red: Troubleshoot‐
ing, 17.
There is a malfunction in charger or battery.
7 Assembling the Hand Vac‐
uum
7.1 Attaching accessories
► Assemble the accessories and attach them to
the nozzle.
0458-006-8321-B
Attaching and Removing the Brush Attachment
80-100%
60-80%
40-60%
20-40%
0-20%
Removing the brush attachment:
► Depress the retaining latch (1) and hold it
► Remove the brush attachment (2).
Attaching the brush attachment:
► Push the brush attachment (1) into the guides
8
8.1
► Push the battery (1) into the battery compart‐
8.2
► Depress both locking hooks (1).
1
2
depressed.
at the suction nozzle as far as it will go.
The brush attachment engages in position with
an audible click.
Removing and Fitting the
Battery
Fitting the Battery
ment (2) as far as stop.
The battery (1) engages in position with a
click.
Removing the Battery
1
The battery (2) is unlocked and can be
removed.
English
2
1
2
11