Advertisement
Step 10
Step
Separate the EXTENSION SLIDES (40MC) from the EXTENSION
å
RAILS (40MA) as shown in the upper diagram below. Be prepared,
the parts are greasy.
Fasten four EXTENSION RAILS (40MA) to the ENDS (A and B). Use
å
eight GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL in to fi nd the other hole that lines up with the hole
in the END. Turn a SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
40MC
Push the black lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Edge with
TWIST-LOCK®
FASTENERS
Open end
Edge with
3S
TWIST-LOCK®
FASTENERS
B
IMPORTANT:
After fastening the
EXTENSION RAILS to the RIGHT END (A),
the SAFETY STOPS should touch the top
edge of the RAILS. If the gap is larger than
1/16", the drawers could lock up and not
open. If this happens, open two drawers
at the same time to override the interlock
system. Remove the drawers to re-adjust
the INTERLOCK TRACK assembly.
40MA
A
Open end
Page 15
Advertisement
